Pre-punched, formed galvanised steel connector for connecting timber members at angles greater than 90°.
These pre-punched and formed galvanised steel timber connectors are ideal for:
Securing jack trusses to hip trusses.
Securing small span half or cutoff trusses to boomerang girder trusses.
Suitable for both left and right hand configuration, Multinail Mitre Plates are installed as follows:
Mitre Plates can also be used wherever specified in AS4440-2004.
The following table shows the recommended Limit State Design capacities for the Multinail Mitre Plate.
|Joint Group||Maximum Limit State Design Capacity (kN)|
|Dead Load||Dead Load + Roof Live Load||Dead Load + Wind Load|
NOTES: The uplift in capacities are derived from AS1720-2010 and are for houses where failure is unlikely to affect an area greater than 25m2. For primary elements in structures other than houses or elements in a house for which failure would be greater than 25m2 these capacities must be multiplied by 0.94. For primary joints in essential services or post disaster buildings multiply by 0.88.
For 2/mitre plates the values can be doubled.
Manufactured from 1.0mm Galvanised G300 Z275 Steel
|Description||Product Code||Reference Code||Carton quantity||Carton kg.|
|75 x 150||TA102||MP75150||100||8.5|
|75 x 150 Left||MPL75150||MPL75150||100||8.5|
|75 x 150 Right||MPR75150||MPR75150||100||8.5|
|30mm x 2.8Ø Multinail Nails (TA302)|
Personalised. Local. Progressive.